Sake Filtering – Is this Muroka (無濾過)?

Sake Filtering – Is this Muroka (無濾過)?

OK, so the bodai moto based sake I am working on, rested for about 1 month after pressing. Normally, I would have racked it after a couple of weeks but the lees were just not dropping out. I have not had a sake that was so slow to drop its leas before. After one month the sake appeared as in the picture below:

Bodai-moto One Month After Pressing
Bodai-moto One Month After Pressing

Not very encouraging in turns of being able to recover a large percentage of the sake as clear sake. Anyway, I had been thinking about filtering sake and thought that this maybe a good batch to give it a try with. You may recall that the fermentation went very slow and I pressed it too early despite it having had more time to ferment than most. The moromi went through stages of smelling like green apples, strawberries and finally banana’s. These aromas have been very strong and are very evident the minute I open the cooler. At one month after pressing the banana aroma continues to be very strong; Ginjo-ka on steroids.

The equipment I used for filtering consists of a 5 gallon Cornelious keg, and a plate filter with a 7 micron filter paper. I also have 3 micron and 1 micron filter paper but I was afraid that the filter would clog and I would lose too much sake. As it turned out the filter was very close to being clogged if not actually clogged at the end of pushing about one gallon of sake with leas through it. The following picture shows the front and back sides of the 7 micron paper filter and the back plate of the filter housing. Continue reading “Sake Filtering – Is this Muroka (無濾過)?”